Effect of Mass Fraction of Molybdenum Disulfide on Tribotechnical Characteristics of Coatings Deposited by a Laser Beam
https://doi.org/10.56304/S2079562922050074
Abstract
The paper considers the process of laser surfacing of copper-based powder with molybdenum disulfide additives on 40Kh steel samples using continuous radiation and transverse beam vibrations with a frequency of 216 Hz. The influence of the mass fraction of molybdenum disulfide on the coefficient of friction, the resistance to bullying and the change in the intensity of wear is shown. The influence of transverse vibrations on the surfacing performance has been studied.
About the Author
V. P. Biryukov
Mechanical Engineering Research Institute of the Russian Academy of Sciences
Russian Federation
Russian Federation
Moscow, 101990
References
1. Quazi M.M. et al. // Lasers Manuf. Mater. Process. 2016. V. 3 (2). P. 67.
2. Wang A.H. et al. // Mater. Sci. Eng. 2008. V. 475 (1−2). P. 312.
3. Xu J., Liu W., Zhong M. // Surf. Coating. Technol. 2006. V. 200 (14−15). P. 4227.
4. Yuan J. et al. // Tribol. Int. 2021. V. 157. P. 106872.
5. Zhao Y. et. al. // Surf. Coatings Technology. 2019. V. 359. P. 485.
6. Yang M.S.et al. // Appl. Surf. Sci. 2012. V. 258 (8). P. 3757.
7. Niu W., Sun R., Lei Y. // Proc. Int. Conf. Electronics and Optoelectronics (ICEOE 2011). 2011. V. 2. P. 321.
8. Liu X.B. et al. // J. Mater. Proc. Technol. 2013. V. 213 (1). P. 51.
9. Yan H. et al. // Surf. Coat.Technol. 2013. V. 232. P. 362.
10. Wang L. et al. // Appl. Surf. Science. 2012. V. 258 (17). P. 6697.
Review
For citations:
Biryukov V.P. Effect of Mass Fraction of Molybdenum Disulfide on Tribotechnical Characteristics of Coatings Deposited by a Laser Beam. Nuclear Physics and Engineering. 2023;14(3):234-239. (In Russ.) https://doi.org/10.56304/S2079562922050074
Views:
22
Email this article 